Page 1 - MPD ML100SER Datasheet
P. 1





ML100SERSeries



Low Cost, Regulated

1W SMT, Single Output

DC/DC Con vert ers


Electrical Specifi cations
Specifi cations typical @ +25°C, nominal input voltage & rated output current, unless otherwise noted. Specifi cations subject to change without notice.
Key Features: Input
• 1W Output Power Parameter Conditions Min. Typ. Max. Units
• Miniature SMT Case 5 VDC Input 4.75 5.0 5.25
• Tight Regulation 12 VDC Input 11.4 12.0 12.6
Input Voltage Range VDC
• -40ºC to +85ºC Operation 15 VDC Input 14.25 15.0 15.75
• Short Circuit Protection 24 VDC Input 22.80 24.0 25.20
• Low 0.24” Profi le Input Filter Capacitor
• >3.5 MHour MTBF Output
• Industry Standard Pin-Out Parameter Conditions Min. Typ. Max. Units
• LOW COST! Output Voltage Accuracy ±3.0 %
Line Regulation For Vin Change of 5% ±0.3 %
Load Regulation For Iout = 10% to 100% ±1.0 %
Output Ripple (20 MHz) See Note 1 10 20 mV P - P
Output Noise (20 MHz) See Note 1 50 150 mV P - P
Temperature Coeffi cient ±0.03 %/ºC
Output Short Circuit Continuous (Autorecovery)
General
Parameter Conditions Min. Typ. Max. Units
Isolation Voltage 60 Seconds 1,000 VDC
Isolation Resistance 500 VDC 1,000 M
Isolation Capacitance 100 kHz, 1V 70 pF
Switching Frequency 100 kHz
Environmental
Parameter Conditions Min. Typ. Max. Units
Operating Temperature Range Ambient -40 +25 +85 ºC
Storage Temperature Range -55 +125 ºC
Cooling Free Air Convection
Humidity RH, Non-condensing 95 %
Physical
Case Size See Mechanical Drawing (Page 2)
Case Material Non-Conductive Black Plastic (UL94-V0)
Weight 0.09 Oz (2.9g)
MicroPower Direct Reliability Specifi cations
292 Page Street Parameter Conditions Min. Typ. Max. Units
Suite D MTBF MIL HDBK 217F, 25ºC, Gnd Benign 3.5 MHours
Stoughton, MA 02072
USA Absolute Maximum Ratings
Parameter Conditions Min. Typ. Max. Units
T: (781) 344-8226 5 VDC Input -0.7 7.0
F: (781) 344-8481 12 VDC Input -0.7 15.0
E: sales@micropowerdirect.com Input Voltage Surge (1 Sec) VDC
15 VDC Input -0.7 18.0
W: www.micropowerdirect.com
24 VDC Input -0.7 28.0
Peak Refl ow Temperature 245 ºC
Lead Temperature 1.5 mm From Case For 10 Sec 300 ºC
Caution: Exceeding Absolute Maximum Ratings may damage the module. These are not continuous operating ratings.
www.micropowerdirect.com
   1   2