Page 1 - MPD ML100SEI Datasheet
P. 1





ML100SEI Series



Low Cost, Single Output

1W High Isolation SMT

DC/DC Con vert ers


Electrical Specifi cations
Specifi cations typical @ +25°C, nominal input voltage & rated output current, unless otherwise noted. Specifi cations subject to change without notice.
Input
Key Features:
Parameter Conditions Min. Typ. Max. Units
• 1W Output Power 5 VDC Input 4.5 5.0 5.5
• Ultra-Miniature SMT Case 12 VDC Input 10.8 12.0 13.2
Input Voltage Range VDC
• 3,000 VDC Isolation 15 VDC Input 13.5 15.0 16.5
• Short Circuit Protected 24 VDC Input 21.6 24.0 26.4
• Single Output Input Filter Capacitor
• -40°C to +105°C Operation Output
• >3.5 MHour MTBF Parameter Conditions Min. Typ. Max. Units
• 14 Standard Models Output Voltage Accuracy ±3.0 %
Capacitive Load 220 µF
• LOW COST!
Line Regulation For Vin Change of 1% ±1.2 %
Load Regulation, See Note 1 See Model Selection Guide
Output Voltage <12 VDC 30
Ripple & Noise (20 MHz), See Note 2 mV P - P
15 VDC, 24 VDC Output 60
Temperature Coeffi cient ±0.03 %/ºC
Output Short Circuit Continuous (Autorecovery)
General
Parameter Conditions Min. Typ. Max. Units
Isolation Voltage 60 Seconds 3,000 VDC
Isolation Resistance 500 VDC 1,000 M
Isolation Capacitance, See Note 3 100 kHz, 0.1V 20 pF
Switching Frequency 100 300 kHz
EMI Characteristics
Parameter Conditions Min. Typ. Max. Units
EMI Compliance, See Note 5 Conducted CISPR22/EN 55022 Level B
EMC Compliance Electrostatic Discharge (ESD) EN 61000-4-2 Level B Contact ±8 kV
Environmental
Parameter Conditions Min. Typ. Max. Units
Operating Temperature Range Ambient -40 +25 +105 ºC
Storage Temperature Range -55 +125 ºC
Cooling Free Air Convection
Humidity RH, Non-condensing 95 %
Physical
Case Size See Mechanical Drawing (Page 2)
Case Material Non-Conductive Black Plastic (UL94-V0)
MicroPower Direct Weight 0.05 Oz (1.52g)
292 Page Street Reliability Specifi cations
Suite D Parameter Conditions Min. Typ. Max. Units
Stoughton, MA 02072 MTBF MIL HDBK 217F, 25ºC, Gnd Benign 3.5 MHours
USA Absolute Maximum Ratings
Parameter Conditions Min. Typ. Max. Units
T: (781) 344-8226
F: (781) 344-8481 5 VDC Input -0.7 9.0
E: sales@micropowerdirect.com Input Voltage Surge (1 Sec) 12 VDC Input -0.7 18.0 VDC
W: www.micropowerdirect.com 15 VDC Input -0.7 21.0
24 VDC Input -0.7 30.0
Peak Refl ow Temperature See Note 6 245 ºC
Lead Temperature 1.5 mm From Case For 10 Sec 300 ºC
Caution: Exceeding Absolute Maximum Ratings may damage the module. These are not continuous operating ratings.

www.micropowerdirect.com
   1   2