Page 3 - MPD ML100SE Datasheet
P. 3



Typical Connection www.micropowerdirect.com













Board Layout
To meet the requirements of EN 55022 Class B, external components C1 and L1 are
required. These components should be mounted as close to the unit as possible.
The output capacitor may be added if a further reduction in output ripple is required. The
recommended value (C3) is gven in the table below. Care must be taken in choosing
the output capacitor not to exceed the maximum capacitive load capability of the unit.

VIN C1 L1 VOUT C3
3.3 VDC 4.7 µF/50V 6.8 µH 3.3 VDC 10 µF
5 VDC 4.7 µF/50V 6.8 µH 5 VDC 10 µF
12 VDC 4.7 µF/50V 6.8 µH 6 VDC 10 µF
15 VDC 4.7 µF/50V 6.8 µH 9 VDC 4.7 µF





Mechanical Dimensions
Pin Connections
Pin Description Pin Description
1-V 4-VOUT
IN
2+VIN 5+VOUT
8NC
NC = No Connection




































Notes:
MicroPower Direct • All dimensions are typical in inches (mm)
• Tolerance x.xx = ±0.01 (±0.25)
• Pin 1 is marked by a “dot” or indentation on the unit
We Power Your Success - For Less!
292 Page Street Ste D Stoughton, MA 02072 • TEL: (781) 344-8226 • FAX: (781) 344-8481 • E-Mail: sales@micropowerdirect.com
   1   2   3