Page 1 - MPD ML100SE Datasheet
P. 1





ML100SE Series



Low Cost, Single Output

Ultra-Miniature SMT

DC/DC Con vert ers


Electrical Specifi cations
Specifi cations typical @ +25°C, nominal input voltage & rated output current, unless otherwise noted. Specifi cations subject to change without notice.
Key Features: Input
Parameter Conditions Min. Typ. Max. Units
• 1W Output Power
3.3 VDC Input 2.97 3.3 3.63
• Ultra-Miniature SMT Case 5 VDC Input 4.5 5.0 5.5
• EN 60950 Approved Input Voltage Range 12 VDC Input 10.8 12.0 13.2 VDC
• 1,500 VDC Isolation 15 VDC Input 13.5 15.0 16.5
24 VDC Input 21.6 24.0 26.4
• Short Circuit Protected
Input Filter Capacitor
• Single Output Output
• -40°C to +105°C Operation Parameter Conditions Min. Typ. Max. Units
• >3.5 MHour MTBF 3.3 VDC Output Models ±5.0
Output Voltage Accuracy
• LOW COST! All Other Models ±3.0 %
Capacitive Load 220 µF
3.3 VIN Models ±1.5
Line Regulation For VIN Change of 1% %
All Other Models ±1.2
Load Regulation, See Note 1 See Model Selection Guide
Ripple & Noise (20 MHz), See Note 2 60 150 mV P - P
Temperature Coeffi cient ±0.03 %/ºC
ML105S-24E & 24V Input Models 1 S
Output Short Circuit, See Note 3
Continuous (Autorecovery)
General
Parameter Conditions Min. Typ. Max. Units
Isolation Voltage 60 Seconds 1,500 VDC
Isolation Resistance 500 VDC 1,000 M
Isolation Capacitance 100 kHz, 0.1V 20 pF
Switching Frequency 300 kHz
EMI Characteristics
Parameter Standard Criteria Level
Radiated Emissions EN 55022 Level B
Conducted Emissions EN 55022 Level B
ESD, See Note 4 EN 61000-4-2 B ±8 kV Contact
Environmental
Parameter Conditions Min. Typ. Max. Units
Operating Temperature Range Ambient -40 +25 +105 ºC
Storage Temperature Range -55 +125 ºC
Cooling Free Air Convection
Humidity RH, Non-condensing 95 %
Physical
Case Size See Mechanical Drawing (Page 4)
Case Material Non-Conductive Black Plastic (UL94-V0)
Weight 0.053 Oz (1.60g)
MicroPower Direct Reliability Specifi cations
292 Page Street Parameter Conditions Min. Typ. Max. Units
Suite D MTBF MIL HDBK 217F, 25ºC, Gnd Benign 3.5 MHours
Stoughton, MA 02072 Safety Standards EN 60950
USA Absolute Maximum Ratings
Parameter Conditions Min. Typ. Max. Units
T: (781) 344-8226 3.3 VDC Input -0.7 5.0
F: (781) 344-8481 5 VDC Input -0.7 9.0
E: sales@micropowerdirect.com Input Voltage Surge (1 Sec) 12 VDC Input -0.7 18.0 VDC
W: www.micropowerdirect.com 15 VDC Input -0.7 21.0
24 VDC Input -0.7 30.0
Peak Refl ow Temperature See Note 5 245 ºC
Lead Temperature 1.5 mm From Case For 10 Sec 300 ºC
Caution: Exceeding Absolute Maximum Ratings may damage the module. These are not continuous operating ratings.
www.micropowerdirect.com
   1   2   3