Page 1 - MPD MG200xxEI Datasheet
P. 1





MG200xEI Series



High Isolation, 2W

Compact MiniDIP

DC/DC Con vert ers


Electrical Specifi cations
Specifi cations typical @ +25°C, nominal input voltage & rated output current, unless otherwise noted. Specifi cations subject to change without notice.
Key Features: Input
Parameter Conditions Min. Typ. Max. Units
• 2W Output Power 5 VDC Input 4.50 5.0 5.50
• Compact MiniDIP Case 12 VDC Input 10.80 12.0 13.20
Input Voltage Range VDC
• 3,000 VDC Isolation 15 VDC Input 13.50 15.0 16.50
24 VDC Input 21.60 24.0 26.40
• EN 60950 Approved
Input Filter Internal Capacitor
• Single and Dual Outputs Output
• >3.5 MHour MTBF Parameter Conditions Min. Typ. Max. Units
Output Voltage Accuracy ±2.5 %
• -40°C to +85°C Operation
Line Regulation For VIN Change of 1% ±1.2 %
• LOW COST Load Regulation, See Note 1 See Model Selection Guide
Output Voltage <12 VDC 60
Ripple & Noise (20 MHz), See Note 2 mV P - P
1.5 kV Isolation 15 VDC, 24 VDC Output 75
Models Temperature Coeffi cient ±0.03 %/°C
Available Output Short Circuit 5 VDC, 12 VDC & 15 VDC Input Continuous (Autorecovery)
24 VDC Input Momentary (1.0 Sec.)
General
Parameter Conditions Min. Typ. Max. Units
Isolation Voltage 60 Seconds 3,000 VDC
Isolation Resistance 500 VDC 1,000 M
Isolation Capacitance 100 kHz, 0.1V 20 pF
Switching Frequency 100 300 kHz
EMI Characteristics
Parameter Conditions Min. Typ. Max. Units
Conducted CISPR22/EN 55022 Level B
EMI Compliance, See Note 4
Radiated CISPR22/EN 55022 Level B
EMC Compliance, Single Output EN 61000-4-2 Level B Contact ±8 kV
Electrostatic Discharge (ESD)
EMC Compliance, Dual Output EN 61000-4-2 Level B Contact ±6 kV
Environmental
Parameter Conditions Min. Typ. Max. Units
Operating Temperature Range Ambient -40 +25 +85 °C
Storage Temperature Range -55 +125 °C
Cooling Free Air Convection
Humidity RH, Non-condensing 95 %
Physical
Case Size 0.787 x 0.394 x 0.323 Inches (20.0 x 10.0 x 8.2 mm)
Case Material Non-Conductive Black Plastic (UL-94V0)
MicroPower Direct Weight 0.08 Oz (2.4g)
292 Page Street Reliability Specifi cations
Suite D Parameter Conditions Min. Typ. Max. Units
Stoughton, MA 02072
MTBF MIL HDBK 217F, 25°C, Gnd Benign 3.5 MHours
USA
Safety Approvals UL 60950, EN 60950
Absolute Maximum Ratings
T: (781) 344-8226
F: (781) 344-8481 Parameter Conditions Min. Typ. Max. Units
E: sales@micropowerdirect.com 5 VDC Input 9.0
W: www.micropowerdirect.com 12 VDC Input 18.0
Input Voltage Surge (1 Sec) VDC
15 VDC Input 21.0
24 VDC Input 30.0
Lead Temperature 1.5 mm From Case For 10 Sec 300 °C
Caution: Exceeding Absolute Maximum Ratings may damage the module. These are not continuous operating ratings.
www.micropowerdirect.com
   1   2