Page 1 - MPD MD100DER Datasheet
P. 1





MD100DER Series



Dual Output, 1W SIP

Tightly Regulated

DC/DC Con vert ers


Electrical Specifi cations
Specifi cations typical @ +25°C, nominal input voltage & rated output current, unless otherwise noted. Specifi cations subject to change without notice.
Key Features: Input
Parameter Conditions Min. Typ. Max. Units
• 1W Output Power
5 VDC Input 4.75 5.0 5.25
• Tight Regulation
Input Voltage Range 12 VDC Input 11.40 12.0 12.60 VDC
• Miniature SIP Case
24 VDC Input 22.80 24.0 25.20
• 1,000 VDC Isolation
Input Filter Internal Capacitor
• 12 Dual Output Models
Output
• >3.5 MHour MTBF
Parameter Conditions Min. Typ. Max. Units
• -40°C to +85°C Operation Output Voltage Accuracy ±3.0 %
• LOW COST Line Regulation For VIN Min to Max ±0.25 %
Load Regulation For IOUT = 10% to 100% ±1.0 %
Ripple (20 MHz) See Note 2 10 20 mV P - P
Noise (20 MHz) 50 100 mV P - P
Temperature Coeffi cient ±0.03 %/°C
±5 VDC Output Models Continuous (Autorecovery)
Output Short Circuit, See Note 3
All Other Models Momentary (1.0 Sec)
General
Parameter Conditions Min. Typ. Max. Units
Isolation Voltage 60 Seconds 1,000 VDC
Isolation Resistance 500 VDC 1,000 M
Isolation Capacitance 100 kHz, 0.1V 60 pF
Switching Frequency See Model Selection Chart
Environmental
Parameter Conditions Min. Typ. Max. Units
Operating Temperature Range Ambient -40 +25 +85 °C
Storage Temperature Range -55 +125 °C
Cooling Free Air Convection
Humidity RH, Non-condensing 95 %
Physical
Case Size 1.083 x 0.374 x 0.472 Inches (27.5 x 9.5 x 12.0 mm)
Case Material Non-Conductive Black Plastic (UL-94V0)
MicroPower Direct
Weight 0.173 Oz (5.2g)
292 Page Street
Suite D Reliability Specifi cations
Stoughton, MA 02072 Parameter Conditions Min. Typ. Max. Units
USA
MTBF MIL HDBK 217F, 25°C, Gnd Benign 3.5 MHours
T: (781) 344-8226 Absolute Maximum Ratings
F: (781) 344-8481 Parameter Conditions Min. Typ. Max. Units
E: sales@micropowerdirect.com
W: www.micropowerdirect.com 5 VDC Input -0.7 9.0
Input Voltage Surge (1 Sec) 12 VDC Input -0.7 18.0 VDC
24 VDC Input -0.7 30.0
Lead Temperature 1.5 mm From Case For 10 Sec 300 °C
Caution: Exceeding Absolute Maximum Ratings may damage the module. These are not continuous operating ratings.
www.micropowerdirect.com
   1   2